永保机械产品分类
    装载机案例推荐
    联系永保机械
  • 商河县永保机械制造有限公司
  • 手机:13964108518
  • 电话:0531-84917777
  • 传真:0531-84917777
  • 邮箱:2533082748@qq.com
  • 网址:www.sdyongbaojixie.com
  • 地址:济南市商河县怀仁镇工业园
    首页 >> 济南装载机配件润滑油如何选用?
    济南装载机配件润滑油如何选用?
    发布时间:2014-12-6 10:19:04    浏览:123次

    济南装载机配件http://www.sdyongbaojixie.com/机油的不足有可能会导致润滑效果差,机械的损坏率变大甚至有可能会引起事故的发生,但事实上油量过多不仅不会使得机械在传动过程中的摩擦力减小,甚至还会使曲轴的转动阻力变大,使得动力消耗的更大,并且在转动过程中容易出现气泡,使得润滑效果不良。在选用润滑剂的时候要选用黏度较小的的润滑剂,因为润滑剂的黏度选的过高的话会使机油的油泵疏松性能变差,流量变小,使得润滑性,散热性变差,发生一些不必要的故障。
    Jinan loader accessories insufficient oil may cause poor lubrication, mechanical failure rate increases may even cause accidents, but in fact does not make too much oil in the transmission process of mechanical friction reduction small, even the crankshaft rotational resistance becomes large, so that more power consumption, and prone to air bubbles during rotation, so that poor lubrication effect. When the lubricant in the selection to choose a small viscosity of the lubricant, since the lubricant viscosity is too high, then selection of an oil pump will loose oil deterioration, the flow becomes small, so that lubrication, heat deterioration occurs some unnecessary failures.
      
    现在的润滑油都根据不同的情况添加了不同程度的添加剂,有的时候机油在使用时间不久之后就开始变黑,但是不要以为这是机油变质需要更换了,由于不同的状况,加入了不同的添加剂,使得不能从单一的角度来判断是否机油变质,需要在多种情景的分析之下,在作出是否需要更换的决定。
    Now oil is added according to different situations with varying degrees of additives, sometimes in time shortly after the oil began to darken, but do not think this is the need to replace the oil deterioration, due to the different conditions, adding a different additives, making it impossible from a single perspective to determine whether oil deterioration, require analysis under a variety of scenarios, the decision whether or not to be replaced.
       
    济南装载机配件http://www.sdyongbaojixie.com/的养护是非常重要的,养护的好使用的时间就一定会增长,这样也能尽量的减少了更换设备所需要投入的成本。
    Jinan loader accessories conservation is very important, a good time to use conservation will certainly grow, so too can try to reduce the need to invest in equipment replacement costs.